AM26LV32EIPWR

AM26LV32EIPWR is the tape-and-reel TSSOP-16 ordering code for the Texas Instruments AM26LV32E quadruple differential line receiver, listed as ACTIVE in the datasheet package option addendum. It runs from a single 3.3 V supply: this is the low-voltage LV family, not the 5 V AM26LS32 also listed in this catalog - the two are pin-compatible but not supply-interchangeable, and every figure here is from the LV datasheet. It supports signalling rates up to 32 Mbps over a -7 V to +7 V common-mode range, with fault protection to -14 V and +14 V, receiver hysteresis of 35 mV typical, power dissipation of 27 mW typical, supply current of 17 mA maximum and IEC 61000-4-2 contact protection of ±8 kV on the bus pins, over -40 °C to +85 °C. The selection point is RS-422 / RS-485 reception in 3.3 V systems: motion control, encoder feedback and industrial serial links designed natively at low voltage rather than level-shifted from a 5 V receiver. Selection advice: confirm the receiver failsafe behaviour your protocol expects on an idle or open bus - hysteresis alone does not define the output state for every idle condition. Parameters verified against the TI AM26LV32E datasheet (package option addendum and electrical characteristics).