MANUFACTURER PART RECORDDRV8833PWPR
Texas InstrumentsDRV8833PWPR is a Texas Instruments dual H-bridge motor driver in HTSSOP-16 PowerPAD, tape and reel — for battery-powered robots, printers and consumer devices driving two DC motors or one bipolar stepper from a single chip. 1.5 A RMS (2 A peak) per bridge over a 2.7 V to 10.8 V supply is the selection point: it runs directly from a single Li-ion cell or a 5 V rail with no extra power stage. Selection advice: the PWP suffix denotes the thermally enhanced HTSSOP-16 — solder the exposed pad to a copper pour, because at 1.5 A the package relies on the board for cooling; R denotes tape and reel. The two bridges can be paralleled to drive one higher-current motor, often cheaper than moving to a larger driver — but stay within the datasheet paralleling guidance. For higher voltage or current rails, look upward within the TI DRV driver family rather than paralleling beyond the datasheet limits. TI lists this part as Active. Parameters verified against the TI official product page.
Power ManagementDual motor driverHTSSOP-16