BQ24610RGER

BQ24610RGER is the tape-and-reel VQFN-24 ordering code for the Texas Instruments BQ24610 standalone synchronous buck battery charger, listed as ACTIVE on the TI buy page and in the datasheet package option addendum. It charges 1 to 6 series Li-ion or Li-polymer cells from a 5 V to 28 V adapter input (33 V absolute maximum), at up to 10 A charge current with ±0.5% charge voltage accuracy and ±3% adapter current accuracy, switching at 600 kHz, covering battery voltages from 2.1 V to 26 V with an off-state battery discharge current below 15 µA, over -40 °C to +85 °C. The selection point is a charger that needs no host firmware: power tools, e-bike and robot packs and industrial handhelds where the charge profile is set by resistors and the system must charge even with a dead processor. Selection advice: the 10 A headline is a silicon figure - inductor saturation, sense-resistor dissipation and the VQFN thermal pad decide the sustainable charge current, so design the power stage for the pack’s real C-rate. Parameters verified against the TI BQ24610 datasheet (package option addendum and electrical characteristics).