TL082IDR

TL082IDR is the tape-and-reel SOIC-8 ordering code for the Texas Instruments TL082 dual JFET-input operational amplifier, listed as Active Production in the current package option addendum. Read on this code — the TL08xI rows of the current datasheet revision (SLOS081 Rev. O, September 2025), this D package falling under the revision’s “all other devices” rows: a recommended total supply of 4.5 V to 40 V, gain-bandwidth of 5.25 MHz typical, slew rate of 20 V/µs typical, input offset voltage of 6 mV maximum at 25 °C and 8 mV maximum over the full range, input bias current of 200 pA maximum at 25 °C and 7 nA maximum over the full range, common-mode rejection of 100 dB typical and quiescent current of 1.4 mA typical per channel, over −40 °C to +85 °C. Its input noise is 37 nV/√Hz typical at 1 kHz on the same “all other devices” row; the 18 nV/√Hz figure elsewhere in that table belongs to the NS/PS-package and M-grade rows, and the rows must not be mixed. An earlier version of this page mixed in superseded-revision figures (a 7 V to 30 V supply, 3 MHz, 13 V/µs and 86 dB); they are withdrawn. The selection point is the JFET input itself: picoamp bias currents suit high-impedance sensor, photodiode and sample-and-hold front ends at a commodity price. Selection advice: the I in this code is the -40 °C to +85 °C industrial grade - do not substitute a commercial-grade TL082 code into an industrial BOM on the strength of the shared family name. Parameters verified against the TI TL082 datasheet SLOS081 Rev. O (package option addendum, §5.3 recommended operating conditions and the §5.8/§5.9 electrical tables, TL08xI rows).