MANUFACTURER PART RECORDUCC27211DDA
Texas InstrumentsUCC27211DDA is a Texas Instruments 120 V half-bridge gate driver in 8-pin SO PowerPAD, tube — for telecom, server and industrial power supplies driving high-side and low-side MOSFETs in half-bridge and full-bridge topologies. 4 A source and 4 A sink with 18 ns propagation delay is the selection point: hard-switching large MOSFET gates without the shoot-through that weaker drivers invite. Selection advice: this is a dual-independent-input part — HI and LI are driven separately and there is no enable pin, so dead time must be enforced by your controller, not the driver. The DDA package thermal pad must be soldered to a ground plane; without it the 4 A peaks overheat the package. Lifecycle note: distributors disagree on this part — DigiKey flags it Obsolete while other channels still list it Active — so treat it as legacy stock: confirm date code and traceability, and state any lifetime-buy quantity in your RFQ. Parameters verified against TI datasheet documentation.
Power ManagementHalf-bridge gate driverSO PowerPAD-8