TMC5160A-TA
Analog DevicesTMC5160A-TA is the tray order code for the Analog Devices (Trinamic) TMC5160A stepper motor controller and driver IC in eTQFP-48 (7 x 7 mm body), covered by the TMC5160A datasheet Rev 1.17. It drives external MOSFETs for coil currents from 1 A to several tens of amps, with up to 256 microsteps, SPI plus Step/Dir and single-wire UART interfaces, SixPoint ramping, StealthChop2, SpreadCycle and StallGuard2 sensorless load detection. The datasheet operational-range table governs the supply: motor and bridge supply VVS is 10 V min to 55 V max (the lower 8 V figure sometimes quoted is a reduced-spec mode with short-to-GND protection not functional), VCC_IO is 3.00 V to 5.25 V, and junction temperature is -40 to +125 °C. Selection advice: the -TA-T code is the same chip on tape and reel, the -WA codes are the QFN-56 wettable-flank variant, and TMC5160-EVAL, TMC5160-BOB and the SilentStepStick are boards built around this IC — not chip order codes.
- MPN
- TMC5160A-TA
- Manufacturer
- Analog Devices
- Family
- Stepper motor controller/driver
- Package
- eTQFP-48
- Manufacturer channel coverage
- Checked by RFQ
- Data last checked
- Commercial check required
- Required order checks
- Suffix, package, date code, lot, source and traceability
Four checks before a commercial offer.
Identity
Exact MPN, manufacturer and suffix
Supply
Supplier type, quantity and freshness
Evidence
Lot, labels, photos and documents
Terms
Price, lead time, payment and shipping
Explore more Integrated Circuits records
Browse existing catalog records — same series first, then the same category and manufacturer. These are not confirmed replacements; compatibility requires engineering review.
TMC5160A-TA FAQ
What should I check before substituting TMC5160A-TA with another Stepper motor controller/driver?
Match the full ordering code, not the series name: package (eTQFP-48), temperature grade and packing all ride on the suffixes. A same-series code in a different package is a different orderable device, so confirm the substitute against the Analog Devices datasheet before changing the BOM.