MANUFACTURER PART RECORDBLM18PG121SN1D
MurataBLM18PG121SN1D is a Murata EMIFIL chip ferrite bead, 120 Ω at 100 MHz (±25%), rated 2 A, DCR 50 mΩ maximum, in 0603 (1608 metric) — the power-line noise filter for DC rails feeding noise-sensitive ICs. The PG power-line series is the selection point: 2 A current handling with only 50 mΩ DCR in a 0603 footprint, so it drops negligible DC voltage while presenting high impedance to high-frequency noise that would otherwise ride the rail into ADCs, PLLs and RF sections. Selection advice: the D suffix denotes tape-and-reel packing; the impedance figure is specified at 100 MHz, so check the Murata Z-f curve against your actual noise band — a 120 Ω part peaks in the VHF range and is less effective at low-MHz switching harmonics, where a higher-impedance sibling helps. Derate current for temperature rise at full 2 A in hot enclosures. This is the general-purpose series, not AEC-Q200 qualified (Arrow lists automotive as No). Evidence: DigiKey/element14 listings confirm 120 Ω @ 100 MHz, 2 A, 50 mΩ DCR, 0603 and Active status.
Passive ComponentsFerrite bead0603