VERIFIED CROSS-REFERENCE
ADS1220IPWR alternatives & equivalent parts
TI precision 24-bit SPI delta-sigma ADC for small sensor signals, with a 4-channel MUX (2 differential or 4 single-ended inputs), low-noise PGA, two programmable IDAC current sources, internal reference and temperature sensor, up to 2 kSPS. — common packages: TSSOP-16. Each candidate below cites its manufacturer datasheet; check the relationship badge before substituting.
3 verified alternatives for ADS1220IPWR
| Alternative | Manufacturer | Relationship | Key differences | Source |
|---|---|---|---|---|
| ADS1120 | Texas Instruments | Pin-compatibleDrop-in: same footprint and pinout. | TI explicitly describes the ADS1120 as the 16-bit pin-to-pin version of the ADS1220: same TSSOP-16 (PW) package and identical pin functions, same SPI interface, PGA gain 1 to 128, two IDACs and 2.3-5.5 V supply. The only functional downgrade is resolution (16 bits instead of 24 bits), while the maximum data rate stays at 2 kSPS. | TI datasheet |
| ADS122C04 | Texas Instruments | Functional alternativeSame function: board or design change needed. | Keeps the same TSSOP-16 footprint, 24-bit resolution, 2 kSPS rate, gain 1 to 128, dual IDACs and 2.3-5.5 V supply, and the analog pins sit in the same positions, including the dedicated reference pair (pin 8 = REFN, pin 9 = REFP on the C04; the 0 suffix belongs to the ADS1220's first reference pair only), but it is not pin-compatible: the interface changes from SPI to I2C, so pins 1/2/3 become A0/A1/RESET and pins 15/16 become SDA/SCL. It also drops the ADS1220's second, multiplexed reference pair (REFP1/REFN1 shared onto the AIN0 and AIN3 pins), and offers 16 I2C addresses via the two address pins. | TI datasheet |
| AD7124-4 | Analog Devices | Functional alternativeSame function: board or design change needed. | A 24-bit, 4-channel sigma-delta ADC with PGA, internal reference and SPI, so it covers the same sensor-measurement role, but it is not pin-compatible: 24-lead TSSOP (or 32-lead LFCSP) versus TSSOP-16, with a completely different pinout and register map. Its supply is also narrower (2.7-3.6 V, or +/-1.8 V, with a separate I/O supply), so it cannot run from the 5 V rail the ADS1220 supports, while its output data rate is much higher at up to 19.2 kSPS versus 2 kSPS. | ADI product page & datasheet |
Pre-replacement checklist
- Confirm the host interface: the ADS122C04 moves the design from SPI to I2C
- Check whether 16-bit resolution is enough before taking the pin-to-pin ADS1120
- Check the supply rail: the AD7124-4 cannot use a 5 V rail; the TI parts accept 2.3-5.5 V
- If you use the IDAC excitation sources (RTD/bridge sensors), confirm count and range on the replacement
Need the exact lot, date code or a second source quoted?
Send the original MPN and the approved alternative. Sourceics reconfirms source, stock, date code and commercial terms before any order — no substitution without your engineering approval.
Request a quote for ADS1220IPWRSource part reference: TI datasheet. Equivalence notes are reference guidance, not a guarantee of fit — always verify against your schematic and layout.