VERIFIED CROSS-REFERENCE
AD8605ARTZ-REEL7 alternatives & equivalent parts
ADI precision low-noise CMOS rail-to-rail input/output single op-amp: 10 MHz gain bandwidth, 65 uV maximum offset (25 C), 8 nV/rtHz noise, on a 2.7-5.5 V supply. — common packages: SOT-23-5. Each candidate below cites its manufacturer datasheet; check the relationship badge before substituting.
3 verified alternatives for AD8605ARTZ-REEL7
| Alternative | Manufacturer | Relationship | Key differences | Source |
|---|---|---|---|---|
| OPA365 | Texas Instruments | Pin-compatibleDrop-in: same footprint and pinout. | A direct footprint swap: the OPA365 in SOT-23-5 (DBV) has the identical pinout (1 OUT, 2 V-, 3 +IN, 4 -IN, 5 V+) and a wider 2.2-5.5 V supply range. It is far faster (50 MHz gain bandwidth, 25 V/us slew rate versus 10 MHz and 5 V/us) and quieter (4.5 nV/rtHz at 100 kHz versus 8 nV/rtHz at 1 kHz — different frequency points), but its offset voltage is looser at 200 uV maximum versus 65 uV maximum, and it draws 4.6 mA typical (5 mA maximum) versus roughly 1 mA. | TI datasheet |
| TLV365 | Texas Instruments | Pin-compatibleDrop-in: same footprint and pinout. | Same SOT-23-5 (DBV) package and identical pinout, 2.2-5.5 V supply, 50 MHz gain bandwidth and 27 V/us slew rate, so it drops directly onto the same footprint. It is not a precision equivalent, however: its maximum offset voltage is 1.9 mV, roughly 29 times the AD8605's 65 uV maximum, so DC accuracy in precision circuits will degrade even though the swap itself is direct. | TI datasheet |
| AD8615 | Analog Devices | Pin-compatibleDrop-in: same footprint and pinout. | ADI's wider-bandwidth sibling in a 5-lead TSOT-23 (UJ-5), the thin variant of the SOT-23-5 footprint, with the same pinout (1 OUT, 2 V-, 3 +IN, 4 -IN, 5 V+). Its maximum offset is 100 uV - looser than the AD8605's 65 uV (the AD8605's 65 uV is the AD8605/AD8606 row at VS = 3.5 V; the dual/quad AD8616/AD8618 rows are 60 uV maximum at 5 V and 65 uV maximum at 2.7 V) - and its noise is 10 nV/rtHz typical at 1 kHz, while bandwidth more than doubles to over 20 MHz, with a 12 V/us slew rate and 150 mA output current; however, its supply ceiling is 5.0 V rather than 5.5 V and it draws 2 mA maximum (1.7 mA typical), so it is a drop-in only on rails of 5 V or below. | ADI datasheet |
Pre-replacement checklist
- Confirm the SOT-23-5 pinout (all three candidates match the AD8605 exactly)
- Check the supply ceiling: the AD8615 stops at 5.0 V, the AD8605 and TI parts allow 5.5 V
- Compare offset class before swapping: the TLV365 is a speed part, not a precision part (1.9 mV max)
- Check quiescent current: the OPA365 draws about 4.6 mA typical versus roughly 1 mA for the AD8605
Need the exact lot, date code or a second source quoted?
Send the original MPN and the approved alternative. Sourceics reconfirms source, stock, date code and commercial terms before any order — no substitution without your engineering approval.
Request a quote for AD8605ARTZ-REEL7Source part reference: ADI datasheet. Equivalence notes are reference guidance, not a guarantee of fit — always verify against your schematic and layout.